T.C. 1179-EL   

CONTACT    PRODUCT INFORMATION    REQUEST INFO    TRADE SHOWS   
MISSION STATEMENT    HOME   

 

Water-Based Liquid Corrosion, Tarnish Preventative and Drawing Compound
TECH BULETTIN [PDF]    MSDS   
T.C. 1179-EL

DESCRIPTION

T.C. 1179-EL, as shipped, is a somewhat translucent fluid liquid with a light greenish color. It possesses a mild amine odor and has a viscosity slightly greater than water. The concentrated material and its solutions are moderately alkaline giving pH values between 8.5 and 9.5 at 20°C. The product is stable and resistant to heat and contamination at unusual degrees in normal use, although adulteration with mineral acids should be avoided. A thin layer of light yellow froth tends to collect upon the surface of the undiluted liquid. This is normal and indicates that the solution is saturated with one of the inhibitors. T.C. 1179-EL is completely dilutable with water to form uniform dispersions of somewhat turbid characteristics, but it leaves films on metals after drying of non-tacky properties. Their high resistances to oxygen results in a special beneficial anti-tarnish attribute when it is applied to silver and copper alloy surfaces. The non-oily properties of the protective films generally permit adhesion of labels and decals or the application of paints frequently used in color-coding metal parts. The films also have certain qualities of lubricity that make them resistant to abrasion and wear, and they aid in the torque and leak-sealant functions of threaded fittings and screw-fasteners.

PURPOSES

T.C. 1179-EL is designed to provide indoor protection against corrosion and tarnish, not only on the surfaces of iron and steel parts, but also on the surfaces of copper, brass, aluminum and aluminum alloys, zinc and galvanized articles, and on silver and silver-plate. The product is unique in its role as a non-oily supplement to heavy zinc phosphate coatings.

APPLICATION

T.C. 1179-EL is applied by tank immersion methods from full-strength down to 5% by volume. The average indoor protective values are normally obtained in the concentration range from 10% to 20% by volume. For more corrosive environments, the use-concentration should be increased as needed. Temperatures employed may be from ambient up to 160°F. No water rinse is required, and the work should be dried by evaporation in air or by forced hot air to set up the protective films.

HANDLING

While T.C. 1179-EL is not a very hazardous material, it should be handled like all chemicals: with intelligent care. It may be irritating to skin, eyes and to mucous membranes when prolonged inhalation of mists and vapors from solutions at elevated temperatures occurs. Wear rubber-type gloves and approved chemical safety goggles. In case of contact, flush affected areas with large volumes of water for at least 15 minutes. This procedure applies to first aid for eye contact in particular. Seek medical attention for eyes. Wash thoroughly after use with soap and water.

STORAGE

T.C. 1179-EL may be stored in general indoor storage areas.

6/2000